Signal Processing Flow Diagram
The attached document shows how various signal processing steps and Central signal processing features are applied to the neural data stream from Blackrock analog and digital (CerePlex) systems.
Related Articles
How to Synchronize Multiple Neural Signal Processors
Introduction Neural Signal Processors can be synchronized to achieve higher channel counts on the combined system. Hardware Requirements Neural Signal Processors with PN 4176 were not all synchronization capable. To check whether your unit is ...
Neural Signal Processor Input Maximum Input Characteristics
Defining MaximumsThe maximum input characteristics information provided below is directly extracted from the Maximum Ratings which is normally mentioned inside the technical datasheets associated with the installed electronics behind the Analog and ...
Interpreting Cereplex μ (Mu)’s Motion Sensing/3D-Axis Data
Attached to this article is a guide on how to interpret the Cereplex μ (Mu) headstage's motion sensing/3D-axis data. If you have questions about the functionality of your Cereplex Mu, please contact support@blackrockneuro.com for more help.
Broadcasting Data from the CerePlex Direct to Multiple Computers
Introduction Unlike the Neural Signal Processor, the CerePlex Direct can normally only interact with one computer at a time through its USB connection. This article covers a method that allows data from a CerePlex Direct to be sent to multiple ...
Communicating Over Serial Port
Required Equipment A null modem serial cable (crossover cable) is needed to send data from the host PC to the NSP. A standard straight through serial cable will not allow the transfer of data. A null modem cable crosses the receive and transmit pins ...