BOSS Was Unable to Start Correctly 0xc0150002

BOSS Was Unable to Start Correctly 0xc0150002

This error indicates that the PC is missing Microsoft Visual C++ Service Pack 1 2005.

You can download it here:

http://www.microsoft.com/download/en/details.aspx?id=26347 

If you would like to read more about this error, you can below:

https://community.rti.com/kb/how-resolve-error-application-was-unable-start-correctly-0xc0150002-click-ok-close-application

    • Related Articles

    • Frequency Out of Range + Low Frequency Stimulation

      The CereStim will claim its minimum frequency as 4 Hz, but there are many cases in which it will not allow the user to deliver a 4 Hz stimulation because the maximum value that can be held in memory is too long to get to that low of a frequency. It ...

    • Gemini Hardware - Central connection issues

      When running Central with Gemini Hardware, users might experience connectivity issues with errors such as "Unable to Open Instrument Network" This can be a result of assigning two different IP addresses on the same ethernet adaptor or having the same ...

    • NSP Gets Stuck in Initializing Step 2

      There is a known bug with NSPs with PNs 7530, 9650, and 10411 where their LCD screen shows "Initializing Step 2" and it gets stuck. This is a known issue associated with the NSPIF board (i.e. the PCI board that the fiber optic cable attaches to) that ...

    • nPlay Troubleshooting Guide

      Attached to this article is a PDF detailing troubleshooting steps regarding nPlay connectivity. If none of these tips are able to help resolve your issue, please send in an email to support@blackrockneuro.com to receive further assistance with your ...

    • How to Synchronize Multiple Neural Signal Processors

      Introduction Neural Signal Processors can be synchronized to achieve higher channel counts on the combined system. Hardware Requirements Neural Signal Processors with PN 4176 were not all synchronization capable. To check whether your unit is ...